LM3406 LED DRIVER

I would use 3 small switches to then set the current. Sign up or log in Sign up using Google. The datasheet defines D at the top pf page 9. By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies. Please enter a message. I've been off and on reading the datasheet for the last week. Since I want to be able to run these at different currents, and several of the calculations call for the current, should I run the numbers for each of the 3 currents I'm planning on, and then get a part that would satisfy the worst case scenario?

Uploader:	Tygonos
Date Added:	1 October 2016
File Size:	45.60 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	95810
Price:	Free* [*Free Regsitration Required]

I would use 3 small switches to then set the current. The Manufacturers reserve the right to change this Information at any time without notice.

I am not familiar with LEDs. I've been off and on reading the datasheet for the last week. The LM please use capital letters is a switch mode current regulator.

It is the switching regulator duty cycle, which depends on the ratio of input to output voltages with allowances made for the switch and the Schottky diodeand is not related to PWM. Or is D not duty cycle? Sign up using Facebook.

Texas Instruments LM3406MHEVAL/NOPB, 1.5 A LED Driver Evaluation Board for LM3406

You have chosen to save the following item to a parts list:. Please enter a message.

I have an Ultimaker and a 3D engraver. The datasheet tell me high power LEDs can be used. Since I'd be PWM dimming them, the duty cycle would vary based on whatever brightness happens to work and it would change as they are fading on and off.

Add to a parts list. Therefore these may lmm3406 stupid questions. What value should I use for D? The datasheet defines D at the top pf page 9. Lm34006 using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of L,3406. If not are there any other more cost effective solutions? This particular one did list part numbers, but as I said most are no longer stocked.

Controlling led array with Arduino with LM

One question is, is that plan a good idea? Right now I'm going through design example 1 and following the instructions on how to calculate the parameters for each component.

Home Questions Tags Users Unanswered. But you can get 4 levels of ked with just 2 switches, by having the switches connect extra resistors in parallel.

I find that that pin is left open in input voltage comparator for PWM dimming.

I would like to feed it into LM and have varying brightness from the Led. Post as a guest Name. By clicking "Post Your Answer", you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is oed to these policies.

To determine whether you will need a heatsink, calculate the temperature rise as shown on page 27 of the datasheet. In my caseis it dim pin is not necessary to connect anything?

Driving W LEDs with lm

The simplicity is that lee are always 3 LEDs in a row. Please do not ask for unpaid help via PM, use the forum. Driving W LEDs with lm Adding an external input diode and using the internal VINS comparator allows the LM family to sense and respond to dimming that is done by PWM of the input voltage. The lm from what I understand would allow me to dim the LEDs hooked up to it with a pwm signal from the arduino; the voltage would be modified by the pwm signal and the current would be fixed.

So I go through the datasheet. Save to parts list Save to parts list.